The setup of the new APLazer is complete.   I receive training on Thursday.  I expect to be back in production Thursday night!

The old vytek system has been replaced.  I couldn't fix it this time.  Too much change in technology so I purchased a new system that has already been received.  Setup should be completed today.  Thank you all for hanging in there with me.  I will be in production soon.

Work to get my laser system back up and running continues. 
When the laser goes down and production stops it's a difficult time for everyone.  I know you've lost a dear friend and need to put this part of the grieving process behind you.  I am truly sorry to keep you waiting but I will get things running again and you will have your memorial to enjoy for a lifetime.  Please continue to hang in there with me.  If this delay creates a problem please let me know and we can work something out.
​Thanks again for your patience and understanding.  Eric

Significant progress yesterday.  The computer that runs my Vytek FX laser system was brought back to life.  Today I need to determine what is operational and what isn't, then load the necessary software and peripheral systems and sync the computer to the laser.  I am optimistic.

FYI... a unique operating system is required to run the Vytek FX Laser so I can't just go out and buy a new computer, I wish I could.  I purchased two backup computers a few years ago for just this reason however turns out both backup units have unexpected memory issues and will not work.  Uugh!

​Thank you for your patience & understanding.